How to use cable safety pricker correctly:
Operate according to the instructions. If the bolt action occurs in the process of pricking but the nail projectile does not explode, please check whether it is tightened. If it is loosened, try again. If the nail projectile does not explode after tightening, please change it. If in the process of pricking, the spring in the gun hall always does not move, and the control box operation is completed, it may be caused by a long time or poor maintenance, can first adjust the strength of the gun bolt to loosen several circles and then empty test, until the spring action once tighten it, continue the test, if it has not moved, please contact the manufacturer.
Safety of this device:
Electronic control to ensure that even if the power supply of the device turns on the "confirm" button and enters the selected mode, it is necessary to confirm twice or re-select the mode; The device will not act automatically if it strays into timing mode. A second confirmation is required to enter the selected mode. Electronic control ensures that even if the power supply of the device is turned on and A certain key of the remote controller is pressed by mistake, the device will not move. Only when the A and B keys on the remote controller are pressed down at the same time can the device move. Electronic control ensures that only after the prompt to stay away from the scene, press the C and D two keys of the remote controller at the same time will the device move. In the timing mode, the remote control does not work, and there will be no misoperation caused by mispressure of the remote control. If "failure please check the device and try again" is displayed on the display, please contact the manufacturer in time and do not open the control box without permission. If the screen shows that the battery is weak, replace the battery in time and remove the battery after each use. Consumable nail projectiles and nail projectiles must be the same as the specifications and models configured at the factory. When installing the pricking device, it is necessary to align the U-shaped groove of the spear head part with the fixing plate to prevent damage to the U-shaped groove caused by the impact force of the pricking device. In the use of the pricking device, if the live ammunition pricking, must use a brush to clean the gun chamber, to prevent the next use of the gun chamber residual debris stuck needle, resulting in the instrument can not work normally. During the use of the instrument, the instrument can only Pierce the cable, not the stick and other items. Because the instrument has a large impact force when it is pricked, it is easy to damage the instrument if it is pricked with sticks and other items.
Cable fault tester series produced by Wuhan Xinshengneng Technology Co., Ltd. has the characteristics of high intelligence, complete functions, wide range of use, accurate test, easy to use and so on. More cable fault tester related articles, all in Wuhan Xinshengneng Technology Co., LTD. Official website: www.whxsn.com!
